How it Installation?
Installation instructions
Step 1 :
1.Disconnect the electrical connect or on to pofthe vertical EGR cooler.
2.Remove the nuts and bolts securing the coolers together.Release the mounting clamps and separate the two coolers by prying on the flanges.
Step 2 :
Remove the upper radiator hose from the the rmostat housing.lf your radiator hose has a single O-ring it is a good idea to replace it with a new double O-ring version.
Step 3 :
1.Remove the coolant tube that was connected from the vertical EGR cooler to the engine. Replace it with the coolant plugs upplied in the kit to block off the hole.
Step 4 :
Install the coolant plug included in the GDP Cooler Upgrade kit.Use the factory bolts that secured the lines in place.
Step 5 :
Install the intake elbow by sliding the tube into the boot.Using supplied M6-1.25x25 Bolts secure the flange to the intake manifold.
Step 6 :
1.Install the bracket. The M10 bolt will be screwed into the support bolt. Secure the transmission dipstick to the bracket using 1/4-20 bolts, nuts, and washers.
2.The bracket will hold the coolant hose connector in place.
Other Related products
Discover unique designs you'll need
Coolant Filtration Kit
2008-2010 6.4L Ford Powerstroke
Exhaust Up-Pipe
2008-2010 6.4L Ford Powerstroke
Exhaust Up-Pipe
2008-2010 6.4L Ford Powerstroke
4" Cat & DPF Delete Pipe
2008-2010 6.4L Ford Powerstroke
5" Dp-Back DPF Delete
2008-2010 6.4L Ford Powerstroke
